The Aztech DSL900E(B) is a Controller-based External ADSL bridged modem. It uses ST Microelectronics' Centaur solution that fully complies to ANSI T1.413 Issue 2, ITU-T G.992.1 (G.dmt) and G.992.2 (G.lite) ADSL standard. It supports Full-Rate ADSL transmission at up to 8Mbps downstream and up to 640Kbps upstream. Furthermore, it is interoperable with major DSLAMs and support standard 10Base-T Ethernet interface cards.

PRODUCT SPECIFICATIONS

ADSL/ATM Support

• Controller-based External ADSL Annex B Modem
• Multi-mode : ANSI T1.413 issue 2, ITU-T G.992.1 (G.dmt) and G.992.2 (G.lite) compliant
• Using Discrete Multi-Tone (DMT) line encoding scheme
• Full Rate transmission at up to 8 Mbps downstream and 1 Mbps upstream
• Rate Adaptive modem at 32 Kbps steps
• ATM Layer with Traffic shaping (UBR/CBR/VBR-nrt)
• AAL ATM Attributes - AAL5
• VPI Range (0-4095) and VCI range (1-65535)
• Multiple PVC up to 8 support
• UNI 3.0, 3.1 and UNI 4.0 ATM Signaling (support for SVCS)
• Spectral compatibility with POTs
• F4/F5 OAM Send and Receive/Loopback supported
• Trellis Coding and Echo Cancellation support
• Built in POTs Splitter

Encapsulation Support

• RFC 1483 Ethernet and IP Encapsulations over ATM PVC
• RFC2516 PPPoE Relay support
• RFC 1577 IP over ATM PVC
• Transparent and Spanning Bridge Support

Network Support

• IEEE 802.1d Transparent Bridge
• 4096 Entries in Bridge MAC Filter Table
• TCP/UDP Application Support
• PPTP Access Concentrator Support (Firmware Upgrade)
• L2TP VPN Support (Firmware Upgrade)

Management Support

• Trivial File Transfer Protocol (TFTP) Server and Client
• Remote management through Telnet console access
• Simple Network Management Protocol (SNMP) version 1 Agent
• Flash ROM upgradable for future feature enhancement
• Web based Management (Firmware Upgrade)

Security Support

• PAP/CHAP for Password Authentication Support

CHIPSET

• Virata VC8410 (Helium) - ATM Communications Controller
• STLC70135A - ADSL DMT Modem and ATM Framer
• STLC70134 - ADSL Analog Front End

Memory:

• 4MB SDRAM
• 1MB Flash ROM

PLATFORM SUPPORT

• OS Independent (supports any platform with an ethernet card installed)

IN BUILT MICRO-FILTER

Used for separation of the ADSL And Telephone signals to prevent mutual interference

Micro-filter is a passive device ensuring that in the even of power failure of any active components, there will be no disruption to the telephone service

• Line Side differential input blocking impedance
• At 20 kHz >2k
• At 30 kHz >3k
• From 5 MHz to 10 MHz >4k
• From 10 MHz to 400MHz >2k
• 1 kHz insertion loss between 600 Ohm resistive at < 0.7
• 1 kHz/2.8kHz slope between 600 Ohm resistive at < 0.8
• DC resistance in Ohms (Tip to Tip, and Ring to Ring < 50, Tip to Ring >10M)
• Longitudinal Balance per IEEE Method (From 200 - 1 kHz > 58dB, From 1 kHz - 3 kHz > 53dB
• Envelope Delay 300 Hz - 2800 Hz is < 100 ms

MTBF

• MTBF = 74279 hours (BelStress V3.10 Reliability Prediction to BellCore Method [TR-NWT-000332])

PTT Approvals

• US (FCC Part 15, FCC Part 68, UL 1950 3rd edition)
• Canada (cUL)
• Europe (CE)
• Singapore (iDA, EMC CE, CB IEC950)
• Malaysia (SIRIM)

EXTERNAL CONNECTORS

• 1 x RJ11 Telephone socket for ADSL line
• 1 x RJ11 Telephone socket for Telephone Handset
• 1 x RJ45 for 10Base-T Ethernet
• 1 x MiniDIN Power Connector
• 1 x On/Off Power Switch
• 9 pin Serial Port for local management

DIMENSION

• Dimension : 220 (L) x 140 (W) x 28 (H) mm
• Weight : 380 g

LED INDICATORS

• 1 x Power LED
• 1 x Ethernet Link Status LED
• 1 x Ethernet Activity LED
• 1 x ADSL Receive LED
• 1 x ADSL Transmit LED
• 1 x ADSL Link Status LED

ENVIRONMENTAL

TEMPERATURE

Operating :

• 10 to 45 Celsius
• 50 to 113 Fahrenheit

Non-Operating :

• -25 to 70 Celsius
• -13 to 158 Fahrenheit

HUMIDITY

• Operating: 30% to 80% Relative Humidity (Non-Condensing)
• Non-Operating : 10% to 95% Relative Humidity (Non-Condensing)

SYSTEM REQUIREMENTS

• Pentium MMX 233MHz (or above) with Ethernet card